A1, A3 ve A5 pinleri hakkında

[metehoca]

Merhabalar, deneyap mini'de A1, A3 ve A5 pinlerinden dijital çıkış alamıyorum. docs ve pin diyagramlarında da ilgili bir bilgi yok ve dijital çıkış olarak kullanılabileceği yazılı.

Bu arada mağazada deneyap mini'nin dökümantasyon menüsünde genişletilmiş pin diyagramı ve teknik resim linkleri çalışmıyor, düzeltilirse iyi olur.

[guidol]

aşağıdaki sayfaları kontrol etmeyi deneyin:
https://docs.deneyapkart.org/en/cont...efinitions-dym

ve daha yeni donanım sürümü için düzeltilmiş pin tanımları:
https://forum.deneyapkart.org/forum/...n-for-the-mini

[metehoca]

aşağıdaki sayfaları kontrol etmeyi deneyin:
https://docs.deneyapkart.org/en/cont...efinitions-dym

ve daha yeni donanım sürümü için düzeltilmiş pin tanımları:
https://forum.deneyapkart.org/forum/...n-for-the-mini

Thanks! Checked your findings and traced esp32-s2 datasheet, a1 (gpio9), a3 (gpio11) and a5 (gpio13) clearly shows input, output and high impedance capable. When using arduino ide, i still can't get digital output from these 3 pins. idk why.

[guidol]

Thanks! Checked your findings and traced esp32-s2 datasheet, a1 (gpio9), a3 (gpio11) and a5 (gpio13) clearly shows input, output and high impedance capable. When using arduino ide, i still can't get digital output from these 3 pins. idk why.

Do you use "ESP32S2 Dev Module" or "Deneyap Mini" in the "Board(s Manager"?
Maybe there is a difference in the GPIO-definition
For my programs in the ARDUINO-IDE I use the "ESP32S2 Dev Module"

Check also the 2 Revisions of the Denayap Mini
because on this Revisions (V2.1=old and mpv1.0=new) the Pins for A1,A3,A5 are on another pin = see attached picture

[metehoca]

Looks like the problem is different, a bit weird. Managed to get A1, A3 and A5 working as outputs. But these 3 pins doesn't start working until i press reset or power cycle the board. Other pins work as soon as upload finishes. I have mpv1.0 btw.

Tried using GPIO numbers (9 for A1, 11 for A3 and 13 for A5), same result. These were happening using Deneyap Mini in board manager.

Switched to ESP32S2 Dev Module, it worked flawlessly without resetting board. Arduino IDE says "Hard resetting via RTS pin..." message after upload and pin works like expected. This message don't show up in Deneyap Mini selection.

Deneyap config don't reset board. Other pins work without resetting, but A1, A3 and A5 pins doesn't work until reset.

Diagnosis done, but it's not a solution I hope someone see this and change the config. Thanks for help